收藏本站
Precautions
(4) If the gas gets in your eyes, rinse them immediately. If it has been inhaled, gargle with water immediately.
(5) When the polymer or gas of the polymer comes in contact with your skin, wash it off with soap and water.
(6) The electrolyte, separator paper, rubber and tube used in the FPCAP are all combustible. When the current value is
extraordinarily high during a short circuit, and assuming the worst possibility, the shorted-out section in the lead wire or
inside the capacitor could create a spark, and cause the resin or tube to catch fire.
Give due consideration to the capacitors mounting methods, mounting positions, pattern design etc.
5. Storage conditions
Do not store capacitors without load more than a year because of potential increased leakage current.
(1) Do not store at high temperatures and high humidity. Store it in a location that is not subject to direct sunlight and that has
low temperatures and humidity (generally, temperatures between 5 and 35oC and a relative humidity of 75% or less).
(SMD type VA/VB series : Temperatures between 5 and 30oC and a relative humidity of 70% or less)
(2) Storage period (SMD type VA/VB series)
Store in an aluminum laminated bag.
Before opening : 1 year
After opening : 1 week (Use up all the products after having opened out. Surplus products should be put into the aluminum
laminated bag, and seal up.)
(3) Baking conditions (SMD type VA/VB series)
When you use it exceeding a storage term, please carry out and use baking by the following conditions.
Temperature: 60(+0, -5) oC
Time: 168hours (only one time)
(4) Store in an airtight plastic bag to keep the leads in good condition.
(5) To keep the leads in good condition, store lead-type the FPCAP for no more than one year.
(6) Do not store in places where water, salt water or oil can directly fall on them, or places where condensation may form.
(7) Do not store in places filled with noxious gas (hydrogen sulfide, sulfurous acid, nitrous acid, chlorine, ammonia, etc.).
(8) Do not store in places exposed to ozone, ultraviolet rays and radiation.
6. Disposal
Please treat the FPCAP as industrial waste when needing to dispose of the FPCAP .
For details, refer to the Operating Precaution Guidelines for the EIAJ RCR-2367C. (Safety Application Guide for fixed
aluminum electrolytic capacitors for use in electronic equipment.)
No part of this publication shall be reproduced without prior written permission of the publisher.
NICHICON CORPORATION / FPCAP ELECTRONICS (SUZHOU) CO., LTD.
5
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
RHT1C331MDN1 CAP ALUM 330UF 16V 20% RADIAL
RI-1515S CONV DC/DC 2W 15VIN 15VOUT
RJ24FW103M TRIMMER 10K OHM 0.5W TH
RJ26FW502 TRIMMER 5K OHM 0.25W TH
RJ6F505 TRIMMER 5M OHM 0.5W TH
RK-1209S CONV DC/DC 1W 12VIN 09VOUT
RKZ-0515D CONV DC/DC 2W 05VIN +/-15VOUT
RL110-101K-RC CHOKE RF 100UH 10% RADIAL
相关代理商/技术参数
RHS20K 功能描述:变阻器 25watt 20K 500V Std Shaft RoHS:否 制造商:Ohmite 类型:Wirewound 功率额定值:25 W 电阻:25 Ohms 电压额定值:500 V 容差:10 % 端接类型:Solder Lug 转数:300 锥度:Linear
RHS20KE 功能描述:变阻器 25watt 20K 500V Std Shaft RoHS:否 制造商:Ohmite 类型:Wirewound 功率额定值:25 W 电阻:25 Ohms 电压额定值:500 V 容差:10 % 端接类型:Solder Lug 转数:300 锥度:Linear
RHS23A 制造商:Carlo Gavazzi 功能描述:RELAY HEAT SINK; Accessory Type:Heat Sink Assembly; Depth:37mm; External Height:103mm; External Length:37mm; External Width:22.5mm; For Use With:Carlo Gavazzi RX1A Thyrex Series 24A Relays; Heat Sink Mounting:DIN Rail; Series:RHS
RHS23B 制造商:Carlo Gavazzi 功能描述:RELAY HEAT SINK; Accessory Type:Heat Sink Assembly; Depth:83mm; External Height:103mm; External Length:83mm; External Width:22.5mm; For Use With:Carlo Gavazzi RX1A Thyrex Series 32A Relays; Heat Sink Mounting:DIN Rail; Series:RHS
RHS250 功能描述:变阻器 25watt 250ohm 500V Std Shaft RoHS:否 制造商:Ohmite 类型:Wirewound 功率额定值:25 W 电阻:25 Ohms 电压额定值:500 V 容差:10 % 端接类型:Solder Lug 转数:300 锥度:Linear
RHS250E 功能描述:变阻器 25watt 250ohm 500V Std Shaft RoHS:否 制造商:Ohmite 类型:Wirewound 功率额定值:25 W 电阻:25 Ohms 电压额定值:500 V 容差:10 % 端接类型:Solder Lug 转数:300 锥度:Linear
RHS250P36BPZAN4153 功能描述:RES 8KVP 250PF +/-10% RoHS:否 类别:电容器 >> 陶瓷 系列:GDZM 标准包装:4,000 系列:- 电容:1000pF 电压 - 额定:50V 容差:±10% 温度系数:X7R 安装类型:表面贴装，MLCC 工作温度:-55°C ~ 125°C 应用:自动 额定值:AEC-Q200 封装/外壳:0805（2012 公制） 尺寸/尺寸:0.079" L x 0.047" W（2.00mm x 1.20mm） 高度 - 座高（最大）:- 厚度（最大）:- 引线间隔:- 特点:- 包装:带卷 (TR) 引线型:-
RHS25100F 制造商:Alpha 3 Manufacturing 功能描述: